Yokogawa 2-Wire Dual Channel Transmitter/Analyzer FLXA21 - Manual (Page 20)

<1. INTRODUCTION AND GENERAL DESCRIPTION>
1-8
IM 12A01A02-01E 5th Edition : Oct. 31, 2013-00
For some errors concerned with setting, a message on the remedy can jump to the relevant
setting directly.
Problem with mA and Process
parameter.
Remedy
Select a correct ‘Process
parameter’ for mA in:
Commissioning >> Output
setup
Fault:
mA configuration error
Figure 1.10 Example of jumping from remedy to setting
If neither a fault is detected nor warning is indicated, “Working properly” is displayed.
If a fault is detected or warning is indicated, up to 3 messages appear.
n Execute & Setup
Allows you to calibrate and configure the instrument. These operations can be protected with a
password.
Execute:
Calibration
HOLD
Temporary output
Setup:
Commissioning
Change language
Start Quick Setup
Execute & Setup
Figure 1.11 Example of Execute & Setup display
1.3 Passwords
Passwords can protect the FLXA21 from other persons’ access except a right operator’s.
Execute:
Calibration/Wash
HOLD
Temporary output
Setup:
Comissioning
Change language
Start Quick Setup
Execute &Setup
Sensor setup
Measurement setup
Output setup
Error configuration
Logbook configuration
Advanced setup
Display setup
Calculated data setup
Commissioning
Settings
Tag
Passwords
Date/Time
Communication
Factory setup
Advanced setup
Execute:
Commissioning:
Entering an empty password
results in disabling the
password check.
Passwords
Figure 1.12 Example of passwords setting
Execute operation and Commissioning operation can be separately protected by each password.
When the Execute password is set, execution of Calibration(/Wash), HOLD or Temporary output
needs to enter the password to start each execution. When the Commissioning password is set,
Commissioning and Start Quick Setup needs to enter the password to start the setting-up.
Refer to the section 4.6.3, 7.5.3, 10.5.3, 13.6.3 or 16.6.3 for details of setting passwords.