Yokogawa YFGW410 - Manual (Page 70)

D3-9
IM 01W02D01-01EN
At this tab, configure the [Enable F2 Port], [IP Address] and [Subnet Mask] settings.
When the [Enable F2 Port] check box is selected, the [IP Address] and [Subnet Mask] items can
be configured.
Default settings are shown below. Make changes as necessary.
Item Description Default setting
Enable F2 Port Enable Field Network2
Check box cleared
(disabled)
Virtual IP Address
Virtual IP address of Field Network 2 connecting from the
host system
192.168.1.101
UNIT1 IP Address
The IP Address of Field Network2 of the YFGW410 connect-
ed to the UNIT1 connector of the cable for redundancy.
192.168.1.102
(Used internally)
UNIT2 IP Address
The IP Address of Field Network2 of the YFGW410 connect-
ed to the UNIT2 connector of the cable for redundancy.
192.168.1.103
(Used internally)
Subnet Mask Subnet mask of Field Network2 255.255.255.0
When the YFGW410 is set for redundant operation and the [Field Network3] tab is selected, a
window similar to Figure D3-6 appears.
The settings are the same as those for Field Network2. Configure the settings as necessary.
Default settings are shown below.
Item Description Default setting
Enable F3 Port Enable Field Network3
Check box cleared
(disabled)
Virtual IP Address
Virtual IP address of Field Network 3 connecting from the
host system
192.168.2.101
UNIT1 IP Address
The IP Address of Field Network3 of the YFGW410 connect-
ed to the UNIT1 connector of the cable for redundancy.
192.168.2.102
(Used internally)
UNIT2 IP Address
The IP Address of Field Network3 of the YFGW410 connect-
ed to the UNIT2 connector of the cable for redundancy.
192.168.2.103
(Used internally)
Subnet Mask Subnet mask of Field Network3 255.255.255.0