Yokogawa YFGW410 - Manual (Page 66)

D3-5
IM 01W02D01-01EN
IMPORTANT
Always connect the host system to Field Network1.
l Field Network2/3
When you are using only one network when connecting the YFGW410 to the host system, al-
ways connect to Field Network1.
When you must separate the network of the host system, use Field Network2, Field Network3, or
both. To do so, in addition to the setting items for Field Network1, a setting to enable the relevant
interface is added to the settings for Field Network2 and Field Network3.
This will be explained using Field Network2 as an example.
When the YFGW410 is set for single operation and the [Field Network2] tab is selected, the tab
shown in Figure D3-3 appears in the main window.
FD0303.ai
Figure D3-3 Field Network2 Setting Tab (for Single Operation)
At this tab, configure the [Enable F2 Port], [IP Address] and [Subnet Mask] settings.
When the [Enable F2 Port] check box is selected, the [IP Address] and [Subnet Mask] items can
be configured.
Default settings are shown below. Make changes as necessary.
Item Description Default setting
Enable F2 Port Enable Field Network2
Check box cleared
(disabled)
IP Address IP address of Field Network2 192.168.1.101
Subnet Mask Subnet mask of Field Network2 255.255.255.0