Yokogawa YFGW410 - Manual (Page 164)

D4-27
IM 01W02D01-01EN
Each log messages is shown with the log level and a time stamp. The log level is expressed by
an icon.
The log levels are as follows.
Icon Log Level Example
Error
Device leaving the wireless system
A Configurator or Monitor operation did not complete normally
Device failure
Warning Remaining battery capacity is below the warning threshold value
Information
Device joining the wireless system
A Configurator or Monitor operation completed normally
Login or logout operation for a tool
The following table shows the messages list.
In the messages, {0} is replaced with device tag name, login name, etc.
Message Log Level
{0} joined to the network. Information
{0} left the network. Error
The security manager rejected {0} joining to the network. Information
{0} Battery Life was below the pre-configured threshold. Warning
{0} PER was beyond the pre-configured threshold. Warning
{0} RSSI was below the pre-configured threshold. Warning
{0} YFGW510 Status Error. Error
{0} YFGW510 Status Error recovered. Information
A downloaded new Radio Firmware for {0} was canceled. Information
Downloading a new Radio Firmware to {0} was successfully finished. Information
Downloading a new Radio Firmware to {0} was failed. Error
After publishing, the publication interval of {0} was beyond a Stale Limit. Error
Sending the publication to {0} started. Information
Sending the publication to {0} stopped. Information
A downloaded new Sensor Firmware for {0} was canceled. Information
Downloading a new Sensor Firmware to {0} was successfully finished. Information
Downloading a new Sensor Firmware to {0} was failed. Error
Gateway read Object Attribute of {0} successfully. Information
Gateway failed to read Object Attribute of {0}. Error
Gateway could not configure Field Device(s). Error
Monitor ({0} changed Active and Standby of YFGW410.) Information
Monitor ({0} activated Maintenance Mode.) Warning
Monitor ({0} activated Normal Mode.) Information
Monitor (Downloading a new Radio Firmware to {0} was started. ) Warning
Monitor (Downloading a new Sensor Firmware to {0} was started.) Warning
Monitor (Downloading a new Backbone Device Firmware to {0} was started.) Warning
Monitor (User executed to apply a new Radio Firmware to {0}.) Warning
Monitor (User executed to apply a new Sensor Firmware to {0}.) Warning
Monitor (User executed to apply a new Backbone Device Firmware to {0}.) Warning
User sent the warm restart command to {0}. Information
User sent the restart as provisioned command to {0}. Information
User Control ({0} changed User Password.) Information
Configurator (System time was changed to {0}.) Information
Monitor ({0} uploaded Technical Information.) Information
Configurator ({0} executed to start download configuration.) Warning
Configurator ({0} downloaded configuration successfully.) Information
Configurator ({0} failed to download configuration.) Error
User Control ({0} added new user account.) Information
User Control ({0} deleted user account.) Information
GUI was shut down by firmware version difference of YFGW410. Information
Monitor (User executed to read Object Attribute of {0}.) Information
{0} logged in to the YFGW410. Information
{0} logged out of the YFGW410. Information
User sent the restart command to {0}. Information
{0} Temperature was beyond a higher threshold. Warning
{0} Temperature was below a lower threshold. Warning