Yokogawa YFGW410 - Manual (Page 56)

D2-4
IM 01W02D01-01EN
IMPORTANT
When launching YFGW410, if nothing is connected to field network interface 1, or if the connect-
ed device is not running, YFGW410 may detect an error and may not launch properly.
IMPORTANT
The network should be configured that the PC which executes the Field Wireless Management
Console can access to YFGW410 through a field network interface, during an operational state.
l PC settings
• When connecting the PC to the maintenance interface
The maintenance interface’s IP address at the time of shipment from the factory is
192.168.200.101. If the IP address of the PC is set as 192.168.200.xxx (xxx being a number
between 1 and 254, excluding between 101 and 106 and the addresses of other devices
connected to the same network segment), communication with YFGW410 becomes pos-
sible.
• When connecting the PC to field network interface 1
The IP address of the F1 port at the time of shipment from the factory is 192.168.0.101. If
the IP address of the PC is set as 192.168.0.xxx (xxx being a number between 1 and 254,
excluding between 101 and 103 and the addresses of other devices connected to the same
network segment), communication with YFGW410 becomes possible.
Because the Field Wireless Management Console is launched after it is downloaded to the PC
from YFGW410, there is no need to install it on the PC.
IMPORTANT
The Field Wireless Management Console cannot be launched via a proxy server. In Internet
Explorer, open the [Tools] menu, click [Internet Options], select the [Connections] tab, click [LAN
settings], and deselect the checkbox next to [Use a proxy server for your LAN].
l Launching the Field Wireless Management Console
After checking YFGW410 to confirm that the RDY LED, which shows the running status, is lit
green, launch Internet Explorer on the PC. To connect, enter the following URL in the address bar
on Internet Explorer.
http://(IP address of the communication port on YFGW410 to which the PC is connected):8080
http://192.168.0.101:8080
When the connection is successfully made, the window shown in Figure D2-1 is displayed.