Yokogawa YFGW410 - Manual (Page 154)

D4-17
IM 01W02D01-01EN
FD0413.ai
Figure D4-13 Restart Confirmation Dialog
Click the [OK] button to restart. Click the [Cancel] button to cancel the restart and close the confir-
mation dialog.
In a backbone device case, there is no restart type selection. The confirmation dialog is shown
by selecting [Restart Device] in the pop-up menu (same as Figure D4-13).
IMPORTANT
In a redundant configuration, do not restart YFGW410 during SYN LED is blinking. The system
will be stop and YFGW410 will generate a fault status. To recover, it is necessary to power off the
YFGW410 then power on again, so the operating status of the YFGW410 should be checked
before restarting.