Yokogawa YFGW410 - Manual (Page 165)

D4-28
IM 01W02D01-01EN
Message Log Level
{0} Voltage was beyond a higher threshold. Warning
{0} Voltage was below a lower threshold. Warning
{0} Link up on B1 Information
{0} Link up on B2 Information
{0} Link up on B3 Information
{0} Link up on B4 Information
{0} Link up on F1 Information
{0} Link up on F2 Information
{0} Link up on F3 Information
{0} Link up on M1 Information
{0} Link up on S1 Information
{0} Link down on B1 Information
{0} Link down on B2 Information
{0} Link down on B3 Information
{0} Link down on B4 Information
{0} Link down on F1 Information
{0} Link down on F2 Information
{0} Link down on F3 Information
{0} Link down on F1 Error
{0} Link down on F2 Error
{0} Link down on F3 Error
{0} Link down on M1 Information
{0} Link down on S1 Information
{0} Redundant status was changed to INIT. Information
{0} Redundant status was changed to STANDBY. Information
{0} Redundant status was changed to ACTIVE. Information
{0} HW Error: Internal interface was down Error
{0} HW Error: PTP Module Error
{0} The connection of SYNCHRONIZATION port was changed. Warning
A downloaded new Backbone Device Firmware for {0} was canceled. Information
Downloading of a new Backbone Device Firmware to {0} was successfully finished. Information
Downloading of a new Backbone Device Firmware to {0} was failed. Error
IMPORTANT
Error messages may require recovery process to solve errors. Refer to the maintenance informa-
tion in the user’s manual for the device for the required action.