Maple Systems PC419C - Manual (Page 90)

1010-1023, Rev 00 Page 78

Disabled Disable the serial port

Enabled D EFAULT Enable the serial port
 Device Mode [Normal]
The Device Mode option is used to set the Serial Port 5 signaling mode.

Normal D EFAULT Sets the serial port mode to normal.

RS422/
RS485
Enables serial port RS-422/485 support.
 Change Settings [Auto]
Use the Change Settings option to change the serial port IO port address and interrupt
address.

Auto D EFAULT The serial port IO port address and interrupt address
are automatically detected.

IO=2D0h;
IRQ=10
Serial Port I/O port address is 2D0h and the interrupt
address is IRQ10

IO=2C0h;
IRQ=10, 11
Serial Port I/O port address is 2C0h and the interrupt
address is IRQ10, 11

IO=2C8h;
IRQ=10, 11
Serial Port I/O port address is 2C8h and the interrupt
address is IRQ10, 11

IO=2D0h;
IRQ=10, 11
Serial Port I/O port address is 2D0h and the interrupt
address is IRQ10, 11

IO=2D8h;
IRQ=10, 11
Serial Port I/O port address is 2D8h and the interrupt
address is IRQ10, 11

IO=2E0h;
IRQ=10, 11
Serial Port I/O port address is 2E0h and the interrupt
address is IRQ10, 11