Maple Systems PC419C - Manual (Page 33)

Page 21 1010-1023, Rev 00
 Mounting: The PC400C Series Panel PC is a heavy device. When mounting
the system onto a rack, panel, wall or arm, please make sure that at least two
people are assisting with the procedure.
 Anti-static Discharge: If a user opens the rear panel of the panel PC, to
configure the jumpers or plug in added peripheral devices, ground themselves
first and wear an anti-static wristband.
3.3 Preinstalled Components
The following components are all preinstalled:
 Motherboard
 DDR3 memory module
 TFT LCD
 Touchscreen
 Power supply
 Inverter board
 System cooling fans
 PCI/PCIe x1 riser card (optional)
 CD/DVD drive (optional)
3.4 Installation and Configuration Steps
The following installation steps must be followed:
Step 1: Unpack the PC400C Series Panel PC.
Step 2: Set the jumper settings.
Step 3: Mount the PC400C Series Panel PC .
Step 4: Connect peripheral devices to the bottom panel of the PC400C Series Panel
PC.
Step 5: Configure the system. Step 0: