Maple Systems PC419C - Manual (Page 58)

1010-1023, Rev 00 Page 46
Step 1: Locate the DB-9 connector. The location of the DB-9 connector is shown in
575H
Figure 1-4 and Figure 1-5.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See
57 6H
Figure 3-28.
Figure 3-28: RS-232/422/485 Serial Device Connector
Step 3: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
3.12.5 SFP Fiber LAN Connectors
The PC400C Series Panel PC has two SFP fiber LAN connectors. The locations of the
connectors are shown in
586H
Figure 1-4 and Figure 1-5. To install an SFP module, refer to
Section 0.