Npacking, 1 unpacking – Maple Systems PC419C User Manual
Page 29
Page 17
1010-1023, Rev 00
2.1 Unpacking
To unpack the panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the panel PC has been properly
installed. This ensures the screen is protected during the installation
process.
Step 1:
Use box cutters, a knife or a sharp pair of scissors to cut the tape that seals the
top side of the box.
Step 2:
Open the box.
Step 3:
Lift the monitor out of the box.
Step 4:
Remove both polystyrene ends, one from each side.
Step 5:
Pull the plastic cover off the panel PC.
Step 6:
Make sure all the components listed in the packing list are present.
Step 0:
NOTE:
It is recommended that the plastic screen protector covering the
display be left in place until installation and construction are
complete.