Maple Systems PC419C - Manual (Page 49)

Page 37 1010-1023, Rev 00
3.10.3 Rack and Cabinet Installation
To mount the PC400C Series Panel PC into a rack/cabinet, please follow the steps below.
Step 1: Secure the rack mounting bracket to two sides of the monitor using the supplied
retention screws. Each bracket requires four screws.
Step 2: Secure the rack mounting bracket to the rack by inserting and tightening the
supplied mounting nuts and bolts. Each bracket requires three nuts and bolts for
installation. Step 0:
3.10.4 Arm Mounting
The PC400C Series Panel PC is VESA (Video Electronics Standards Association)
compliant and can be mounted on an arm with a 100 mm interface pad. To mount the
PC400C Series Panel PC on an arm, please follow the steps below:
Step 1: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and
that the arm has a 100 mm interface pad. If the mounting arm is not
VESA compliant, it cannot be used to support the PC400C Series
Panel PC.
Step 2: Once the mounting arm has been firmly attached to its surface, lift the PC400C
Series Panel PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
PC400C Series Panel PC.