Lincoln Electric IM10178 POWER FEED 84 U.I. CONTROL BOX User Manual
Page 71
B-35
OPERATION
POWER FEED 84, POWER FEED 84 DUAL
Parameter
Name and Description
P.504
Mode Select Panel Lock
Selects between several Mode Select Panel lockout preferences. When a Mode
SelectPanelselectionislockedandanattemptismadetochangethatparameter,
amessagewillbedisplayedonthelowerdisplayindicatingtheparameterislocked.
•AllMSPOptionsUnlocked=AlladjustableparametersontheModeSelectPanel
areunlocked.
•All MSP Options Locked = All knobs and buttons on the Mode Select Panel are
locked.
•Start&EndOptionsLocked=TheStartandEndparametersontheModeSelect
Panelarelocked,allothersareunlocked.
•WeldModeOptionLocked=TheweldmodecannotbechangedfromtheMode
SelectPanel,allothersModeSelectPanelsettingsareunlocked.
•Wave Control Options Locked = The Wave Control parameters on the Mode
SelectPanelarelocked,allothersareunlocked.
•Start,End,WaveOptionsLocked=TheStart,EndandWaveControlparameters
ontheModeSelectPanelarelocked,allothersareunlocked.
•Start,End,ModeOptionsLocked=TheStart,EndandWeldModeSelectpara-
metersontheModeSelectPanelarelocked,allothersareunlocked.
ThisparametercanonlybeaccessedusingPowerWaveManagersoftware.
P.505
Setup Menu Lock
Determinesifthesetupparameterscanbemodifiedbytheoperatorwithout
enteringapasscode.
•No=The operator can change any set menu parameter without first
enteringthepasscodeevenifthepasscodeisnon-zero(default).
•Yes=Theoperatormustenterthepasscode(ifthepasscodeisnon-zero)
inordertochangeanysetupmenuparameters.
ThisparametercanonlybeaccessedusingPowerWaveManager.
P.506
Set User Interface Passcode
Preventsunauthorizedchangestotheequipment.Thedefaultpasscodeis
zero which allows full access. A nonzero passcode will prevent unautho-
rized: changes to memory limits, saving to memory (if P.502 = Yes),
changestosetupparameters(ifP.505=Yes).
If someone repeatedly enters an invalid passcode 5 times in a row, the
passcodewillbeautomaticallysetto9999,whichisaninvalidcodeandthe
interface can no longer be unlocked. PWManager is required to reset the
passcodeorunlockthemachine.
This parameter can only be accessed using Power Wave Manager soft-
ware.
USER DEFINED PARAMETERS
Range
AllMSPOptions
Unlocked
AllMSPOptions
Locked
Start&End
OptionsLocked
WeldModeOption
Locked
WaveControl
OptionsLocked
Start,EndWave
OptionsLocked
Start,End,Mode
OptionsLocked