Lincoln Electric IM10178 POWER FEED 84 U.I. CONTROL BOX - Manual (Page 10)

A-3
INSTALLATION POWER FEED 84, POWER FEED 84 DUAL
SAFETY PRECAUTIONS
ELECTRIC SHOCK CAN KILL.
• ONLY QUALIFIED PERSONNEL SHOULD PERFORM
THIS INSTALLATION.
• Turn the input power OFF at the
disconnect switch or fuse box before
attempting to connect or disconnect
input power lines, output cables or
control cables.
• Do not touch the wire drive, drive rolls, wire coil or
electrode when welding output is ON.
• Wire feeder may be connected to a piece of automatic
equipment that may be remotely controlled.
• Do not operate with covers, panels or guards removed.
• Do not let the electrode or wire spool touch the wire
feeder housing.
• Insulate yourself from the work and ground.
• Always wear dry insulating gloves.
• The lift bail is insulated from the wire feeder
enclosure. If an alternate hanging device is used, it
must be insulated from the wire feeder enclosure.
MOVING PARTS can injure.
• Keep away from moving parts.
• Wear Eye Protection
-------------------------------------------------------------------
LOCATION
For best wire feeding performance, place the Power Feed 84 on
a stable and dry surface.
Do not submerge the Power Feed 84.
The Power Feed 84 is rated IP2X and is suitable for indoor use.
When suspending a wire feeder, insulate the hanging device
from the wire feeder enclosure.
For bench models, do not angle spindle for the wire spool or coil
more than 15 degrees downward. (See Figure A.A)
WARNING
15 DEGREES MAXIMUM
figure a.a