Teledyne LeCroy SierraNet M408 User Manual Ver.1.40 - Manual (Page 84)

Teledyne LeCroy Trigger and Filter Settings in Easy Mode
82 SierraNet M408 User Manual
Set the parameters for the following:
 Port # ‐ Select the port.
 RX Eq DC gain ‐ Select value from the drop‐down list.
 RX Eq‐8G DC gain ‐ Select value from the drop‐down list.
 RX Eq Control ‐ Select value from the drop‐down list.
 RX Eq ‐8G Control ‐ Select value from the drop‐down list.
 Advanced ‐ Clicking Advanced displays the Advanced Probe Setting dialog with
the RX/TX tab selected (see
Figure 2.55 ). Enter the desired values for each of the
parameters . Select the RX/TX 8G tab (see Figure 2.56 on page 83 ) and enter the
desired values for each of the parameters.
 Splitter ‐ Clicking Splitter displays the Splitter Settings dialog with the Serdes tab
selected. (see
Figure 2.57 on page 84 ). Enter the desired values for each of the
parameters. Select the SFP tab (see Figure 2.58 on page 85 ) and enter the
desired values for each of the parameters. Select the Splitter tab (see Figure 2.59
on page 86 ) and enter the desired values for each of the parameters.
 Restore Factory Settings ‐ Restores the factory settings.
 Apply Selected Settings to All ‐ Applies the currently selected settings.
Figure 2.55: Advanced Probe Setting Dialog - RX/TX Tab