beautypg.com

Adding a sequence – Teledyne LeCroy SierraNet M408 User Manual Ver.1.40 User Manual

Page 222

background image

LeCroy Corporation

Scenario Example

220

 

 

SierraNet M408 Protocol Analyzer User Manual

Figure 4.16: Naming a Scenario

Adding a Sequence

To add a Sequence click Add State in the Sequence 1 panel.

You create a sequence one state at a time. The application numbers states consecutively 
from 0 up (1, 2, 3, and so on).

By default, the name of the first sequence in a Scenario is Sequence 1. The name of the 
first state is State 0. To change the name of a sequence or state, or to associate a 
description with it, click the name of the sequence or state..

1. Drag 6‐Byte Any SCSI Command under FCP as the Event to display the dialog. 

Figure 4.17: Adding an Event for Sequence 1

2. Click OK to close the 6‐Byte Any SCSI Command dialog box.
3. After adding an Event, to add an Action in the Sequence 1 panel, drag and drop 

Monitor/Count.
The Monitor/Count dialog box displays (see 

Figure 4.18 on page 221

).