Teledyne LeCroy SierraNet M408 User Manual Ver.1.40 - Manual (Page 196)

LeCroy Corporation InFusion Scenarios
194 SierraNet M408 Protocol Analyzer User Manual
Figure 4.2: Add Device to Project Dialog
Note: You can select only one Jammer port at a time when using the AJA configuration.
To record traffic from other ports after the InFusion modifies (jams) them, select a
combination of ports that have Jammer/Analyzer specified under them. The different
configurations accommodate different possible user setups and requirements.
Important Information for Jammer and Analyzer
Jammer intercepts and delays traffic on both directions simultaneously, so Originator
sends to Jammer, Jammer delays and sends to Responder, Responder sends to Jammer,
Jammer delays and sends to Originator. However, Jammer modifies traffic in one
direction only: from Originator to Responder, or from Responder to Originator.
When AJA port configuration is selected, the user MUST connect P2 to P3 directly
(externally) and the other ports should be connected to the FC ports being jammed. In
this configuration, P1/P4 shows before jam traffic and P2/P3 shows after jam traffic. As a
result, the capture/trigger resource of ”Request, Reply” should only be used considering
the effect of the Jammer (delay, modification and jamming).
4.5 InFusion Scenarios
You can create and execute InFusion Scenarios. A Scenario is a test script that defines
how InFusion monitors and modifies line traffic.
4.5.1 Scenarios Overview
You create Scenarios on a host machine running the Net Protocol Suite application. You
then specify the Scenarios for execution on an InFusion device.
The Net protocol Suite application provides a user friendly interface for building
Scenarios. The interface prompts you for simple decisions and choices from drop‐down