Teledyne LeCroy SierraNet M408 User Manual Ver.1.40 - Manual (Page 73)

SierraNet M408 User Manual 71
Trigger and Filter Settings in Easy Mode Teledyne LeCroy
Manual Calibration
You can manually calibrate the probe settings.
Figure 2.42: Manual Calibration Dialog
Set the parameters for the following:
 Port # ‐ Select the port.
 RX Eq DC gain ‐ Select value from the drop‐down list.
 RX Eq Control ‐ Select value from the drop‐down list.
 Advanced ‐ Clicking Advanced displays the Advanced Probe Setting dialog (see
Figure 2.43 . Enter the desired values for each of the parameters.
 Splitter ‐ Clicking Splitter displays the Splitter Settings dialog with the Serdes tab
selected. (see
Figure 2.44 on page 73 ). Enter the desired values for each of the
parameters.elect the SFP tab (see Figure 2.50 on page 78 ) and enter the desired
values for each of the parameters. Select the Splitter tab (see Figure 2.51 on
page 79 ) and enter the desired values for each of the parameters.
 Restore Factory Settings ‐ Restores the factory settings.
 Apply Selected Settings to All ‐ Applies the currently selected settings.