Teledyne LeCroy SierraNet M408 User Manual Ver.1.40 - Manual (Page 218)

LeCroy Corporation InFusion Scenarios
216 SierraNet M408 Protocol Analyzer User Manual
4.5.12 Scenario Libraries
You can create any number of Scenarios, which you then can archive on your host
machine’s hard drive. Libraries are windows that hold Scenarios.
Note:
Each library is a separate *.ifc file.
4.5.13 Traffic Direction
The direction for traffic modification is defined on a global basis for the entire Scenario. In
other words, any Scenario Action that modifies line traffic only affects the traffic flowing
in the direction established at the top of the Scenario, in the Scenario Properties.
Scenario Events can be monitored in either direction, and therefore the parameters for
Events provide the ability to specify the intended direction for monitoring traffic for that
Event.
You identify direction of traffic change, or modification, in terms of traffic origin. The
application uses the following conventions:
 From P1/P3: Change is made to traffic coming from Port 1 or Port 3 (for exam‐
ple, CRC error is injected into traffic stream sent from P1/P3 to P2/P4).
 From P2/P4: Modification is made to traffic coming from the Port 2 or Port 4 (for
example, CRC error is injected into traffic stream sent from P2/P4 to P1/P3).
Figure 4.10: Traffic Direction
To copy an Event or Action, right‐click on the Event or Action and select Copy. 
Right‐click and select Paste.
You can also remove, cut and copy a selected Event or Action.
You can double‐click the State name and edit it.
4.5.14 Copy and Paste Scenarios
You can copy and paste scenarios from one project to another project. Perform the
following steps to do so:
1. Select the scenario you want to copy in either the scenario name tab and select
Copy or in the Library pane and right‐click and select Copy Scenario (see Figure 4.11
on page 217 ).