Teledyne LeCroy SierraNet M408 User Manual Ver.1.40 - Manual (Page 147)

SierraNet M408 User Manual 145
Advanced Mode (User‐Defined) Teledyne LeCroy
Figure 2.94: Filter Settings Dialog
10. If you choose Capture Everything, you can select Idles for exclusion.
11. Select Filter In Selected Patterns or Filter Out Selected Patterns to select patterns
for inclusion or exclusion (see Figure 2.94). See “Ethernet Patterns (Easy Mode)” on
page 67 .
12. Choose pattern(s) and click the > button to add them for capture or exclusion. You
define each pattern the same way as in Easy mode ( “Ethernet Patterns (Easy Mode)”
on page 67 ).
13. Click Capture Nothing to run the trace without capturing anything.
14. Click on the checkboxes to Always Filter Out Idles, RRDY or ports 1 through 8.
15. Select ARBFF, NOS, VC_RDY, Before ports are up, or Training Pattern. ARBff, NOS and
VC_RDY are ordered sets that show up frequently and are of little use in most cases,
and selecting allows you to specifically filter them out. Before ports are up will filter
everything before the ports are up, to save buffer space and allow to concentrate on
the parts important to the user. Training Pattern will similarly filter out all Training
Patterns
16. Check the Truncate Payload option to truncate payload after x‐number of Dword(s)
0 bytes. (see Figure 2.94 ).