Teledyne LeCroy SierraNet M408 User Manual Ver.1.40 - Manual (Page 204)

LeCroy Corporation InFusion Scenarios
202 SierraNet M408 Protocol Analyzer User Manual
The following table describes the Presets that can be used as FC Events.
TABLE 4.2: Events and their Descriptions (FC)
MPCP Refer to section “MPCP Pattern” on page 107.
Address Resolution
Protocol Refer to section “Address Resolution Protocol Pattern” on
page 108.
Link Layer Discovery
Protocol Refer to section “Link Layer Discovery Protocol Pattern” on
page 109.
Internet Protocol Refer to section “Internet Protocol Pattern” on page 110.
iSCSI Refer to section “iSCSI Pattern” on page 111.
VLAN Refer to section “ISL Patterns” on page 113.
ISL Refer to section “ISL Patterns” on page 113.
CN‐Tag Refer to section “CN Tag Patterns” on page 114.
VN‐Tag Refer to section “VN Tag Patterns” on page 114.
Trill Frame Refer to section “LLC” on page 115.
Protocol Errors Refer to section “Protocol Errors” on page 117.
Event Description
User Patterns
Most Recent Lists the most recent Events.
New User Group Lists the new user groups.
Presets
Timers/External
Timer
The Event occurs when the timer expires.
Other Trigs Analyzer: the Event occurs when the Analyzer triggers.
External: the Event occurs when the external Trigger In is
asserted.
Basic
Ordered Set
Refer to section “Ordered Set” on page 120 .
Basic Link Service Refer to section “Basic Link Service” on page 124 .
Link Control Frame Refer to section “Link Control Frame” on page 125 .
Link Speed The Event occurs when the link is at the specified speed.
Both Linkup The Event occurs when both ports are out of electric idle.
Event Description