Teledyne LeCroy SierraNet M408 User Manual Ver.1.40 - Manual (Page 21)

SierraNet M408 User Manual 19
Expandability Teledyne LeCroy
3. Connect the male end of the sync cable to the SYNC IN port of the other SierraNet
M408 (see Figure 1.8 on page 19 .)
Figure 1.8: An Example of Connecting two SierraNet M408 Analyzers
Connecting to Sierra FC M8-4 and Sierra M164 Analyzers via the CATC Sync Expansion
Card
You can connect and control any of the following analyzers:
 SierraNet M408
 SieraNet M168
 Sierra FC M8‐4
 Sierra M164
Select File > New Project to display the Add Device to Project dialog (see Figure 1.9 on
page 20 ). Select the desired analyzer and click OK.
You can also create hybrid Ethernet/FC traces when the SierraNet M408 is daisy‐chained
to either of the devices (using the sync cards).
This is similar to the CrossSync functionality, but is done internal to the application,
automatically.
You can connect to any of the off‐line devices to create a dummy project and use the
project when you are connected to a device.