Fairbanks X SERIES PR 5220 ETHERNET TRANSMITTER - Manual (Page 5)

Table of Contents
05/11 4 51209 Revision 2
5.2 SWITCHING ON THE INSTRUMENT .................................................................................. 29
5.2.1 Resetting the Instrument, Activating 'DHCP' 29
5.2.2 Searching the Instrument in the Network Using 'IndicatorBrowser' 30
5.3 OPERATION USING A PC .................................................................................................. 30
5.3.1 Operation Using the VNC Program 30
5.3.2 Operation Using Internet Browser 31
5.3.3 INFO Function 32
5.3.4 Setup Function (VNC) 33
5.3.5 Setup Menu 33
5.3.6 Calibration Menu 34
5.4 CALIBRATION .................................................................................................................... 35
5.4.1 Displaying Calibration Data 35
5.4.2 Increased Resolution (10-Fold) 35
5.4.3 Selecting the Calibration Mode 36
5.4.4 New Calibration 36
5.4.5 Changing the Calibration 36
5.4.6 Determining the Maximum Capacity (Max) 37
5.4.7 Determining the Scale Interval 38
5.4.8 Determining the Dead Load 39
5.4.9 Possible error messages 39
5.4.10 Calibration with Weight (by Load) 40
5.4.11 Determining span without weight 40
5.4.12 Calibration with mV/V Value 41
5.4.13 Calibration with Load Cell Data (“Smart Calibration“) 42
5.4.14 Subsequent Dead Load Correction 43
5.4.15 Linearization 43
5.4.16 Test Value Determination/Display 44
5.4.17 Finishing/Saving the Calibration 44
5.4.18 Parameter Input 45
5.4.19 Legal-for-Trade Operation 47
5.4.20 Multiple Range Scale/Multi-Interval Scale 47
5.5 ERROR MESSAGES ........................................................................................................... 48
5.5.1 Measuring Circuit Error Messages 48
5.5.2 Testing the Measuring Circuit 48
5.6 CONFIGURING GENERAL PARAMETERS ........................................................................ 49
5.6.1 Serial Ports 49
5.6.2 SMA Protocol 50
5.6.3 Operating Parameters 51
5.6.4 Fieldbus Parameters 52
5.6.5 Network Parameters 53
5.7 LIMIT VALUES, DIGITAL INPUTS AND OUTPUTS ............................................................ 54
5.7.1 Conditions for Limit Values and Digital Inputs, States for Outputs 54
5.7.2 Configuring Digital Inputs and Outputs 55
5.7.3 Configuring Outputs 55
5.7.4 Configuring Inputs 56
5.7.5 Configuring Limit Values 58
5.8 ANALOG OUTPUT .............................................................................................................. 60
5.8.1 Adapting the Analog Output 61
5.9 CONFIGUREIT PROFESSIONAL ....................................................................................... 62
5.9.1 Installation 62
5.9.2 Starting the Program 64
5.9.3 Creating a New Project 64
5.9.4 Defining a New Configuration 65
5.9.5 Establishing the Communication to the Instrument 66
5.9.6 Transferring a Data Set from the Instrument to the PC 67
5.9.7 Saving the Current Data Set on the PC 67
5.9.8 Modifying a Data Set 68