Fairbanks X SERIES PR 5220 ETHERNET TRANSMITTER - Manual (Page 32)

Section 5: Commissioning
05/11 33 51209 Revision 2
5.3.4 Setup Function (VNC)
Press to configure the main operating parameters. The instrument configuration depends on the
application and the plug-in cards installed.
Calibration is in a simple dialogue. Compliance with the relevant (verification) standards must be
checked by the person commissioning the instrument or the verification officer. To protect the
calibration data from overwriting, close the CAL switch on the back panel of the instrument. On
legal-for trade instruments, the CAL switch must be sealed in the closed (write-protected) position;
see Chapter 5.1.1.
5.3.5 Setup Menu
- Serial ports parameter
- Remote display , Builtin RS232
- SMA not used , Builtin RS232, Slot 1 .. 2 RS485, Slot 1 ... 2 RS
232
- Param Builtin RS232, Assigned to, Protocol, Baud rate., Bits, Parity,
Stop bits,
- Operating parameter
- AccessCode Access code for changes
- SetTareKey Tare&reset tare, tare&tare again, disabled
- SetZeroKey Only when not tared, reset tare on zeroset , disabled.
- Fieldbus parameter Only for PR 5220/01 and /04, see Chapter 5.6.4
- Network parameter Hardware address (read only), Instrument name, IP address,
Subnet mask, Standard gateway, VNC-Client (access restriction)
- Calibration New, Modify, Param, see Chapter 5.3.6
-Limit parameter
- Limit 1/2/3 on/off Limit 1/2/3 'on'/ 'off', Action, Condition; see Chapter 5.7.5
-Digital I/O parameter
- Output 1/2/3 Configuring outputs; see Chapter
- Limit 1/2/3 on/off Inputs, Action, Condition; see Chapter 5.7.4
- Analog output parameter Gross, Net, Select, Transparent; see Chapter 5.8