Fairbanks X SERIES PR 5220 ETHERNET TRANSMITTER - Manual (Page 17)

Section 3: Installing the Instrument
05/11 18 51209 Revision 2
3.1 Network Port
The network port is built in as standard equipment. The LEDs on the connector indicate whether the
port is functioning.
Remote operation of the instrument from the PC is
possible; install VNC program version 3.3.7 on the PC.
For setting the network address, see Chapter 5.2.2.
Transfer rate: 10 Mbit/sec, 100Mbit/sec,
full/half duplex, auto-detection
Connection
method: Point to point
Cable: CAT 5 patch cable, shielded twisted pair
Cable impedance: 150 ohms
Connection:
RJ45 socket on top of housing