Micromod MOD: 30ML Functions Data Base Reference - Manual (Page 129)

MOD 30ML Functions
CONFIGURATION EXAMPLES
Display Operation
Unless other changes were made in the strategy to cause a different behavior, the instrument
will come up in a manual mode with a local set-point. The output is displayed on the bottom
line. Pressing the scroll key once causes the set-point to be displayed on the bottom line.
Pressing the scroll key a second time causes the totalized value to be displayed on the
bottom line and an up arrow to be illuminated.
To enter the totalizer commands menu, press the up key while the totalized value is being
displayed on the bottom line. The action of “RESET” will appear on the bottom line and “ENT”
will flash next to the scroll key. Pressing the enter key (scroll key) causes the reset operation
to be enacted and transfers the operator to the totalizer display. If the enter key is not
pressed the action will time out, reset will not be enacted, and the operator will be prompted
to exit the totalizer commands menu.
This same operation applies to the STOP, RUN and HOLD commands. Each of these
commands are accessed after entering the totalizer commands menu and pressing the up
key for each command.
Pressing the enter key when “EXIT” is displayed on the bottom line causes the totalizer
commands menu to close returning the operator to the totalized value display.
3-35