GF Signet 8900 Multi-Parameter Controller - Manual (Page 19)

19 Signet 8900 Multi-Parameter
F1 123.45 GPM
P3 4.32 pH
F1 123.45 GPM
F2 54.321 GPM
Ratio F1:F2
2.27
P3 4.32 pH
L4 19.49 cm
Rst1 1234567.8
Gallons >
Perm1 12345678
Gallons
Volume
Vol4 246. 8 m3
Menu Directory:
>
Menu Directory:
Channel Settings
Menu Directory:
Hold Inputs
Menu Directory:
Relay
Menu Directory:
Output
Menu Directory:
Calibration
Menu Directory:
Options
Menu Directory:
System Setup ENTER
T1 Units:
ºC ºF
e ert t la t a e etting
eturn t ie
eturn t Menu
Saving
View
Menu Directory
Menu
Edit
Sa e an return t Menu
C1 Units:
uS/cm >
C1 TDS:
2.0000 uS/PPM >
T1 Units:
º >
C1 TC Mode:
Pure Water >
C1 TC Slope:
2.00% >
C1 Decimal:
**.*** >
C1 Average:
Med >
ENTER
ENTER
2s
10 min
ime ut
10 min
ime ut
10 min
ime ut
7. Operational Overview
The 8900 Multi-Parameter Controller belongs to the ProcessPro family of instruments. Each member of this family features a digital
display and a four-button keypad for system set-up and general operation. This section contains a description of keypad functions, a
general operation fl owchart, and View mode details for the 8900.
Keypad Functions
The four buttons of the keypad are used to navigate display modes according to the descriptions in this table. Notice that the function
of each button may change depending on the display mode.
7.1 General Operation Flowchart
The four display modes of the 8900 are layered as shown in the fl owchart below. Keypad symbols illustrate basic navigation within and
between these modes.
•
View: View mode is normal operation for the 8900. After system setup is completed, all measurement values for each channel,
plus the status of any analog outputs and relays will be available. See Section 8.4: Automatic Display Confi gurations and Section
8.5: Other Automatic Displays for details.
• Menu Directory: The Menu Directory provides access to seven separate menus for set-up and operation.
There are two ways to access the Menu Directory from View.
1. Scroll to the Menu Directory item and press the Right-arrow button.
2. From any item in View, press and hold the ENTER button for 2 seconds.
• Menu: The current setting for each item in a Menu can be viewed and selected for editing from this mode.
• Edit: Access to this mode is password protected. Use the Standard password (UP-UP-UP-DOWN), or create a custom Enhanced
password (see Section 14.1: Password Security). Entering the correct password one time allows access to all editable items in all
menus, until a return to View mode.
Pressed
simultaneously Display Mode
Edit
Scroll DOWN R T through
flashing items, or advance
flashing cursor fi fi
Save new setting
Escape to menu item
without saving new setting
Scroll through flashing items,
or edit flashing character
Function
Menu Select menu item for editing No function
Return to
Menu Directory
Scroll through items in Menu
ENTER
Select menu Menu Directory
Scroll DOWN through items
in Menu Directory
Scroll through items in
Menu Directory
Return to View
View o to Menu Directory No function Scroll through items in View
Select items
marked with
Multi-Parameter
Controller
C1 2.50 µS/cm
F2 58.43 GPM
Relay 1 Relay 2
ENTER