GF Signet 2734-2736 pH_ORP Electrodes Disassembly - Manual

NOTES: UNLESS OTHERWISE SPECIFIED
COPYRIGHT 2011 GEORG FISCHER SIGNET LLC. ALL RIGHTS RESERVED. THIS DRAWING IS THE PROPERTY OF GEORG FISCHER
SIGNET LLC AND IS SUBJECT TO COPYRIGHT AND OTHER INTELLECTUAL PROPERTY PROTECTION. IT IS NOT PERMITTED TO COPY,
REPRODUCE OR TRANSMIT THIS DRAWING TO THIRD PARTIES WITHOUT PRIOR PERMISSION FROM GEORG FISCHER SIGNET LLC.
C
Georg Fischer Signet LLC
3401 Aero Jet Avenue El Monte, California U.S.A 91731-2882
PRODUCT END-OF-LIFE
DIS-ASSEMBLY INSTRUCTIONS
273X pH/ORP SENSOR
9 DIGIT CODE DRAWING NO. REV.
NA
3-273X.749 A
DWG SIZE FILE NAME SCALE: SHEET
B
3_273X_749.dwr NA 1 OF 1
A INITIAL RELEASE 02/05/14 H. LO
THE INTENT OF THIS DOCUMENT IS TO PROVIDE GUIDANCE TO RECYCLERS ON THE PRESENCE OF MATERIALS
AND COMPONENTS AT THE PRODUCT/SYSTEM LEVEL, AS REQUIRED BY THE EU WASTE ELECTRICAL AND
ELECTRONIC EQUIPMENT (WEEE) DIRECTIVE. THIS DOCUMENT SHOULD ALSO HELP DIRECT RECYCLERS TO
PROPER METHODS FOR REMOVING PARTS AND GENERAL PRODUCT DIS-ASSEMBLY INSTRUCTIONS.
THIS UNIT MUST BE RECYCLED OR DISCARDED ACCORDING TO THE REQUIREMENTS DEFINED IN THE LOCAL
AND NATIONAL REGULATIONS.
DIS-ASSEMBLY INSTRUCTIONS:
THESE INSTRUCTIONS APPLY TO THE FOLLOWING PART NUMBERS:
3-2734
3-2735
3-2736
THESE UNITS CONSIST OF PCB ASSEMBLIES WHICH ARE ENCAPSULATED IN SOLID EPOXY, AND CANNOT
BE DIS-ASSEMBLED. WE RECOMMEND THAT THE ENTIRE UNIT BE TREATED AS ELECTRONIC WASTE.