Burkert Type 8611 - Manual (Page 94)

94
FunctionsoftheConfigurationLevel
12.19. DSPL - setting the display
In this menu, the following settings for the display can be made:
• Activation of the background lighting
• Define what value or what manipulated variable should be displayed after switching on the voltage.
Setting the display in the menu:
DSPL
FACT
NO
L OFF
YES
L OFF
PVAL
CMD
BOTH
SETP
The background lighting remains switched on continuously.
The background lighting switches on when the button is
pressed and switches off automatically after 60 seconds.
Display process actual value
Display manipulated variable
(only for continuous control (MODE
= SCV, 4 – 20 or 0 – 10)
see chapter 12.3.2)
Display set-point value and process
actual value
Display set-point value
Figure 69: DSPL; Setting the display
display description
PVAL Display process actual value. Depending on the unit selected in the UNIT menu
(see chapter 12.4) the corresponding process actual value with unit is displayed.
In the case of cascaded control, the temperature and the flow-rate value are displayed alter-
nately. In the case of ratio control, the two flow-rate values are displayed alternately.
CMD Display manipulated variable. Depending on the actuating element selected in the MODE
menu (see chapter 12.3) the following is displayed:
PRZV: Display manipulated variable for control of proportional valve in [%]
4 – 20: Display manipulated variable for control of analog actuating element in [mA]
0 – 10: Display manipulated variable for control of analog actuating element in [V]
The CMD function is not available for selection for the actuating elements PCV, 2P – T and
3P – T.
BOTH Set-point value (SETP) and process actual value (PVAL) are shown on one display
SETP Display set-point value. Depending on the control variable selected in the MODE menu
(see chapter 12.3) the following is displayed:
SET: Display set-point value for process control
RATI: Display set-point value for ratio control
Table 36: Display DSPL
english
Type 8611