Burkert Type 8611 User Manual
Page 47
47
FunctionsoftheConfigurationLevel
SCV
FREQ
**
)
PT
**
)
NORM
PCV
4 – 20
0 – 10
2P – T
3P – T
Continuous control using proportional
valve and selection of PWM frequency
Quasi-continuous control
using process valve
Continuous control
using 4 - 20 mA standard signal
Continuous control
using 0 - 10 V standard signal
Quasi-continuous 2-state control with
time-proportional control for opening
or closing
Quasi-continuous 3-state control with
time-proportional control for opening
or closing
Select
PWM frequency
Select
control times
Select
control times
operating principle
Select
control times
operating principle
MODE
selection of actuating element
selection of process value input
UNIT
Confirm selection
Accept and save changes
after saving, all parameters are reset
to the default values.
selection of control variable
Frequency input
(can only be set for
MODE = T+F, T-F, F, RATI, 2P-T, 3P-T) PT
PT100 sensor
(can only be set for
MODE = T+F, T-F, T, 2P-T, 3P-T)
4 - 20 mA or 0 - 10 V standard signal
(can be set for all control variables)
YES
*
)
NO
*
)
*
)
The query YES/NO is only displayed
if the control variable or the selection
of the actuating element has been
changed.
**
)
The display depends on the control variable previously set in this
menu (see “Figure 26: MODE; Selection of the control variable”)
Figure 27:
MODE; Selection of the actuating element and of the process value input
english
Type 8611