Burkert Type 8611 - Manual (Page 39)

39
FunctionsoftheProcessOperatingLevel
11.5. SET - set-point value default for process control
In the case of process control, the set-point value default can be entered in the MANUAL operating state using
the
SET menu.
Process control is active if all control variables have been set in the MODE menu except for RATI.
Setting the set-point value default in the menu:
Back to operating state
AUTOMATIC
SET
BACK
030.0
SET * )
Enter a value between 0.00 and 9999
(depends on the decimal places selected in the
UNIT menu).
* ) Menu option is only available if internal set-point
value default was selected (see chapter “12.5.
SETP / RFAC - Selection and scaling of set-
point value default / entry of ratio factor”).
Process operating level
< 1 s
Figure 20: SET; Set-point value default for process control
11.6. RFAC - ratio factor default for ratio control
In the case of ratio control, the ratio factor can be entered in the MANUAL operating state using the RFAC menu.
The ratio control is active if the RATI control was set in the MODE menu.
Setting the ratio factor in the menu:
Back to operating state
AUTOMATIC
RFAC
BACK
0.000
RFAC * )
Enter a value between 0.000 and 9.999.
* ) Menu option is only available if internal set-point
value default was selected (see chapter “12.5.
SETP / RFAC - Selection and scaling of set-
point value default / entry of ratio factor”).
Process operating level
< 1 s
Figure 21: RFAC; Ratio factor default for ratio control
english
Type 8611