Burkert Type 8611 - Manual (Page 45)

45
FunctionsoftheConfigurationLevel
12.2. Menu options of the configuration level
MODE
selection of control variable, actuating element and process value input.
See Chapter 12.3
UNIT
selection of measuring units and decimal places.
See chapter 12.4
SETP
selection and scaling of set-point value default.
See chapter 12.5
RFAC
entry of ratio factor for ratio control (MODE = RATI).
See chapter
12.5
S_IN
scaling of sensor input signal ( 4 - 20 ma or 0 - 10 v).
See chapter 12.6
AOUT
scaling of analog output (4 - 20 ma or 0 - 10 v).
See chapter 12.7
CALI
calibration of the analog inputs and outputs.
See chapter 12.8
KFAC
entry of K-factor for flow-rate measurement.
See chapter 12.11
FILT
setting of the filtering factor.
See chapter 12.12
PARA
setting of the controller parameters.
See chapter 12.13
B_IN
configuration of the binary input.
See chapter 12.14
B_O1
configuration of binary output 1.
See chapter 12.15
B_O2
configuration of binary output 2.
See chapter 12.16
VALV
test function and setting of the control range.
See chapter 12.17
CODE
code protection.
See chapter 12.18
DSPL
setting of the display.
See chapter 12.19
FACT
resetting to factory settings.
See chapter 12.20
U_XX
display of program version.
See chapter 12.21
A_XX
display of software version.
See chapter
12.21
END leaving the configuration level See chapter 12.22
Table 14: Menu options of the configuration level
english
Type 8611