Part 2 - transducer & rtd installation – Dynasonics TFXP Series Transit Time Ultrasonic Flow Meter User Manual
Page 35
Rev. 5/09
- 2.17 -
TFXP
6. Secure with the thumb screw. Ensure that the screw rests in
the counter bore on the top of the transducer. (Excessive
pressure is not required. Apply just enough pressure so that
the couplant fills the gap between the pipe and transducer.)
7. Place the second transducer in between the mounting rails
near the dimension derived in the Transducer Spacing section.
Read the dimension on the mounting rail scale. Slide the
transducer clamp over the transducer and secure with the
thumb screw.
Figure 2.12 — D010-2102-010 Mounting Track Installation
PART 2 - TRANSDUCER & RTD INSTALLATION