Datamax-O'Neil A-Class Mark II Operator’s Manual - Manual (Page 91)

A-Class Mark II 81
Step Action Displayed Message Comment
M
Complete a table (see
example below) using
three new measurements,
as follows:
(A) Raise the printhead
assembly. Place the
label (attached to
liner) in the Media
Sensor then lower and
latch the Head Lift
Lever. Record the
sensor reading as P.
(B) Raise the printhead
assembly. Place the
liner, notch, or mark
in the Media Sensor
then lower and latch
the Head Lift Lever.
Record the sensor
reading as G (or M).
(C) Raise the printhead
assembly. Remove all
media from the Media
Sensor then lower and
latch the Head Lift
Lever. Record the
sensor reading as E.
GAIN TRAN
*18 (0 – 31)
- or, for reflective media:
GAIN REFL
*18 (0 – 31)
Where ‘yyy’ represents the current
sensor reading.
 The re-sampled values may
differ from those previously
noted. This is normal; do not
readjust the Media Sensor.
N
Press the ESC Key and
then the DOWN Key. Press
the ENTER Key. SENSOR LEVELS
The sensor readings must now be
entered into the printer.
Selected Gain Table
Gain Number P (Paper) G (Gap) or M (Mark) E (Empty)
18 173 42 9
(Continued)