Datamax-O'Neil A-Class Mark II Operator’s Manual - Manual (Page 47)

A-Class Mark II 37
Print Control (continued)
Menu Item Details
PRESENT DISTANCE
Sets the label stop position, where:
(0 – 4.00 in.)
AUTO 0.00 Is the label output distance. The default setting (Auto)
configures this distance according to the positioning
requirements of the attached device (e.g., tear bar,
cutter, etc).
 When set to 0.01 in., NONE is assumed; a zero (0)
positioning value will be used.
TOF PRECEDENCE
Allows an override of label format data when the form
length is exceeded, where:
DISABLED
Prints labels formats without TOF truncating.
ENABLED
Ends the label at the next TOF, truncating any print
data that extends past this mark.
CUSTOM ADJUSTMENTS Allows slight, printer-specific adjustments, where:
DARKNESS
32 (1 – 64) Controls the printhead strobe time (see HEAT) to fine-
tune the solid areas of an image.
CONTRAST
32 (1 – 64) Fine-tunes the gray areas of an image.
ROW ADJUST
0000 (
– XXX – XXXX DOTS)
Shifts the vertical SOP position to fine-tune ROW
OFFSET; see Appendix B.
 If shifting in the negative direction, modify
PRESENT ADJUST (below) by the same amount.
COLUMN ADJUST
000 (
– XXX – XXX DOTS)
Shifts both the horizontal SOP position and the LABEL
WIDTH termination point to the right to fine-tune
COLUMN OFFSET; see Appendix B.
PRESENT ADJUST
000 (
– XXX – XXXX DOTS)
Adjusts the label stopping position to fine-tune
PRESENT DISTANCE; see Appendix B.