Datamax-O'Neil A-Class Mark II Operator’s Manual - Manual (Page 49)

A-Class Mark II 39
Printer Options (continued)
Menu Item Details
CUTTER
Controls the Cutter option, where:
MODE
Sets the detection method and response of the printer,
where:
DISABLED
Disables the option.
AUTO
Detects, enables, and sets the label stop location for
the cutter; if not detected, the option will be ignored.
ENABLED
Enables and sets the label stop location for the cutter;
if not detected, a fault will be generated.
CUT BEHIND
Allows a number of small labels to queue before a cut
is performed, increasing throughput, where:
 This mode can be used without a cutter to allow
the presentation of an extra label, with retraction
occurring upon the next job or feed operation.
(0 – 2)
0
Is the queue number.
 After a fault or unknown label position, a leading
edge cut will be performed to ensure against extra
length on the first label; otherwise, cutting will
occur only as specified.
RIBBON SAVER Controls the Ribbon Saver option, where:
DISABLED
Disables the option.
AUTO
Detects enables the option. If not detected, the option
will be ignored.
ENABLED
Enables the option. If not detected, a fault will be
generated.