Datamax-O'Neil A-Class Mark II Operator’s Manual - Manual (Page 71)

A-Class Mark II 61
Communications (continued)
Menu Item Details
NETWORK REPORT
Allows viewing or printing of the network status
report, where:
VIEW Displays the report.
PRINT
Prints the report:
NETWORK REPORT
WED 03:15PM 23JUL2008
CURRENT PRINTER INFO
MACO: 00:0D:70:0B:8B:B9
IP ADDRESS: 192.168.10.26
SUBNET MASK: 255.255.255.0
GATEWAY: 192.168.10.26
DHCP: ENABLED
SNMP: ENABLED
PORT NUMBER: 9100
NETBIOS NAME: DMX_038BB9
WLAN MODULE
MODULE FW VERSION: 4.3.0.24
RADIO FW VERSION: 1.1.1.111.8.4.0.145
PORT STATUS: CONNECTED: ESS
SSID: 000B2802D55E
MACR: 00:0B:28:02:D5:5E
BSS ADDRESS: PROVIDED BY DHCP
SET FACTORY DEFAULTS
Returns the factory-programmed values, where:
YES
Restores the default settings.
 A reset will occur and all settings will be restored
except CUSTOM ADJUSTMENTS and calibrations.
NO
Exits without changing the current settings.
HOST SETTINGS Sets host communication parameters, where:
HOST TIMEOUT
Sets the period that an interface port can be idle
before timeout occurs, where:
(1 – 60 SEC)
10 Is the time (in seconds) when downloads timeout, and
that must elapse before alternate port or alternate
parser processing can occur.
CONTROL CODES Allows changes to the software command
interpretation controls, where:
STANDARD CODES
Sets these interpretation codes: Hex 01 = SOH
command; Hex 02 = STX command; count-by = ^;
Hex 1B = ESC; Hex 0x0D = Carriage Return
ALTERNATE CODES
Sets these interpretation codes: Hex 5E = SOH
command; Hex 7E = STX command; count-by = @;
Hex 1B = ESC; Hex 0x0D = Carriage Return
ALTERNATE CODES 2
Sets these interpretation codes: Hex 5E = SOH
command; Hex 7E = STX command; count-by = @;
Hex 1B = ESC; Hex 0x7C = Carriage Return
CUSTOM CODES
Sets interpretation codes, where:
STANDARD CODES
SOH STX CR CNTBY
01 02 0D 5E
Are the codes according to your definition.
 Standard codes serve as default placeholders.