Datamax-O'Neil A-Class Mark II Operator’s Manual - Manual (Page 55)

A-Class Mark II 45
Printer Options (continued)
Menu Item Details
END OF PRINT
Sets the type of output signal generated to indicate
EOP, where:
LOW PULSE
Outputs a low pulse upon completion.
HIGH PULSE
Outputs a high pulse upon completion.
ACTIVE LOW
Outputs a logic low upon completion.
ACTIVE HIGH
Outputs a logic high upon completion.
RIBBON LOW
Sets the low ribbon signal (as determined by RIBBON
LOW OPTIONS; see Section 4.2.1), where:
ACTIVE LOW
Outputs a logic low when the roll size reaches the
setting.
ACTIVE HIGH
Outputs a logic high when the roll size reaches the
setting.
SLEW ENABLE
Selects the type of input signal required to initiate
label slew, where:
STANDARD
Triggers slew with a low signal.
LOW PULSE
Triggers slew with a low pulse.
HIGH PULSE
Triggers slew with a high pulse.
ACTIVE LOW
Triggers slew with a low signal.
ACTIVE HIGH
Triggers slew with a high signal.
ERR ON PAUSE (APP2)
Sets the output when a service required fault occurs
(Applicator Interface Card Type 2 equipped only),
where:
ENABLED
Enables the output signal.
DISABLED
Disables the output signal.