Datamax-O'Neil A-Class Mark II Operator’s Manual User Manual
Page 83
A-Class Mark II
73
Prompts and Condition Messages (continued)
Displayed Message
Description
Action
REMOVE RIBBON
PRESS ANY KEY
The TEST Key was pressed and
held, or CLEAN HEAD NOW was
selected, but ribbon is installed.
Remove ribbon and press any key
to proceed.
SAVE CHANGES?
Database changes were made
that require confirmation.
Press YES to accept the changes,
or NO to discard them.
If required, a reset will
automatically occur.
SUCCESSFUL
PRESS ANY KEY
The selected operation was
successfully completed.
Press any key to continue.
SYSTEM INITIALIZING
The power switch has been
turned ON or a reset has
occurred.
No action is required. Wait briefly
while the process completes.
SYSTEM RESET
IN PROGRESS
A reset has occurred.
No action is required. Wait briefly
while the process completes.
UNCALIBRATED
The Media Sensor is not
calibrated.
Perform calibration; see Section
5.2.
WAITING FOR DATA
SOP signal has been received,
but the printer awaits label
data.
Send a format from the host.
WAITING FOR SIGNAL
The printer awaits a SOP signal.
Send the SOP signal from the
applicator
to the GPIO port.
XXXX OF XXXX
PRINTING
A print job is in process, as
indicated by the batch total and
remaining label count.
No action is required.