Datamax-O'Neil A-Class Mark II Operator’s Manual - Manual (Page 86)

76 A-Class Mark II
Step Action Displayed Message Comment
G
Observe the calibration
result.
CALIBRATION COMPLETE
Calibration was successful.
 If ‘Warning Low Backing’ is
displayed, calibration was
successful (for possible
messages see Section 5.1).
H
Press the ESC Key
repeatedly to exit menu
mode.
CALIBRATION COMPLETE
Followed by...
READY
When calibrating gap or
reflective media, press and hold
the FEED Key until at least one
label is output.
The printer is now ready for use.
5.2.2 Advanced Entry

Advanced Entry will override all previous calibration settings and should only be used
when Standard Calibration attempts fail. Ensure that the correct SENSOR TYPE is selected
(see Section 4.2.1) before staring this procedure.
Advanced Entry is an alternate calibration method for special-case media types, where sensor
readings are taken using different sampling algorithms and from a list of these readings the best
algorithm is selected for manual entry into the database. Follow the steps below to perform an
Advanced Entry Calibration:
Step Action Displayed Message Comment
A Turn ON the printer.
CANNOT CALIBRATE
-or-
UNCALIBRATED
Wait briefly for the printer to
initialize.
(Continued)