Datamax-O'Neil A-Class Mark II Operator’s Manual - Manual (Page 133)

A-Class Mark II 123
Appendix A
Module Assignments
Module Assignments
Designator Size Type / Use
D
1024 KB
(default size)
DRAM [1] . Default, as assigned (see SYSTEM SETTINGS /
DEFAULT MODULE, Section 4.2.4). Storage for graphics,
fonts, and label formats.
512 KB FLASH. Storage for graphics, fonts, and label formats.
G [2]
See [3],
below.
FLASH (Main Logic CCA). Storage for graphics, fonts, and
label formats.
F Dependant
External SDIO device (if option equipped). Storage for
graphics, fonts, and label formats.
H Dependant
External USB device (if option equipped). Storage for
graphics, fonts, and label formats.
I Dependant
External USB device (if option equipped). Storage for
graphics, fonts, and label formats.
X
See [3],
below.
FLASH (Main Logic CCA). Storage for graphics, fonts, and
label formats.
Y 128 KB FLASH. Main Logic CCA. Reserved for EFIGS.
[1] When power is removed from the printer, stored data will be lost.
[2] Availability and size is dependent upon Main Logic CCA type; reference the Configuration Label.
Also, Flash memory has a limited number of writes (approximately 100,000) and is intended for
permanent (or semi-permanent) storage.
[3] Modules G and X are partitioned to equal the sum of the total space available, approximately
6.5MB.