Datamax-O'Neil A-Class Mark II Operator’s Manual - Manual (Page 85)

A-Class Mark II 75
Step Action Displayed Message Comment
E
Proceed according to the
media type:
•
Die-Cut –Remove a label
or two from the liner
then install the media.
Position the Media
Sensor under the liner
area and press the ESC
Key.
•
Notched (or Reflective) –
Install media. Position
the Media Sensor under
a notch (or black mark)
and press the ESC Key.
•
Continuous – Press the
ESC Key.
For die-cut media:
SCAN BACKING
PRESS ESC KEY
- Or, for reflective media:
SCAN MARK
PRESS ESC KEY
- Or, for continuous
media:
REMOVE LABEL STOCK
PRESS ESC KEY
This sets the gap (or mark)
value, where ‘yyy’ represents
the current sensor reading.

(1) See Section 3.2 for sensor
adjustment instructions.
(2) Do not position a perforation
over the sensor when taking
the sample.
(3) For small notches or
reflective marks, ensure that
the labels exit straight from
the printer.
(4) Unless otherwise noted, do
not move the Media Sensor
after this step.
F
Proceed according to the
media type:
•
All media except
Continuous – Position
label material (and liner,
if any) over the sensor
then press the ESC Key.
• Continuous – Install
media. Position the
Media Sensor under the
stock and press the ESC
Key.
SCAN PAPER
PRESS ESC KEY
This sets the paper value, where
‘yyy’ represents the current
sensor reading.

(1) If using preprinted media,
ensure that the area placed
over the sensor is free of
text, graphics, or borders.
(2) See Section 3.2 for sensor
adjustment instructions.
(Continued)