Ocean Optics SpectraSuite - Manual (Page 156)

A: Experiment Tutorials
144 000-20000-300-02- 201110
 At any time, you can select a sample from the table at the top of the window and click
Remove Sample to discard the point. Once enough points exist to compute a regression,
the
will be enabled to allow the current set of samples to be saved to
disk for later retrieval.
 Click when you have entered enough points to generate a regression line.
Loading Calibration from an Existing File
a. Select Load calibration from file to recall a calibration from known solutions that was
performed previously. The following window appears (the example below is in Windows
XP format):
b. Select a file that was previously saved with in the Calibrating from
Solutions of Known Concentration wizard (see Calibrating from Solutions of Known
Concentration , Step h.). When an appropriate file is selected, the name of the compound
and concentration units appear near the bottom of the window.
c. Click . The resulting window is the same as if you had just entered those
values from a known concentration: