EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 89)

To load the current playlist, continue as follows:
6. Press PLST to load the current playlist on a player channel (it cannot be empty).
To exit the playlist mode:
7. Press the RECORD key to return to E2E mode.
Notes:
• If the new playlist is not empty, it is automatically loaded on the selected player
channel (in 3 PGM mode) or on the PGM (in PGM/PRV mode) and it becomes the
current playlist.
• If the new playlist is empty, the system will ask you whether you want to copy the
current playlist at this new location.
Note
Page 1 contains playlists 10 to 19, Page 2 contains playlists 20 to 29, and so on.
In the VGA Interface
To set the current playlist, proceed as follows:
1. From the clip screen, press END to access the playlist bank.
2. Press DOWN ARROW to select the playlist that you want to define as the current
playlist.
3. Press ENTER on the selected playlist to set it as the current playlist.
How to Recall and Load a Playlist
You can only recall and load a playlist if this is not empty.
To load a playlist on a player channel, proceed as follows:
1. Access the desired playlist bank by pressing F10 from the requested page.
2. Select the playlist to load with the F1-F10 keys.
The selected playlist becomes current and is displayed on the LCD display.
3. Press PLST key on the Remote Panel to load the current playlist.
If the new playlist is not empty, it is automatically loaded on the selected player channel
(in 3 PGM mode) or on the PGM (in PGM/PRV mode) and it becomes the current playlist.
If the new playlist is empty, the system will ask you whether you want to copy the current
playlist at this new location.
5.5.2. Rolling a Playlist
How to Roll a Playlist
After recalling a playlist, you will roll the playlist using the pre-defined speed of each clip.
Use the PLAY key to start rolling the playlist.
OPERATION MANUAL Multicam LSM 11.02
5. Playlist Management 79