EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 182)

8.9. Working with Mapped Network
Cameras
If you have activated the Authorize cam mapping parameter (p.10.1 F1) and define
mapped network cameras (p.10.1) in the Operational Setup menu of the Remote Panel,
you can use other network cameras as if they were local cameras.
The clipping on mapped cameras follows the same rule as for local cameras. Clips
created will be copied as local clips in the corresponding positions.
Two limitations must be noted in the mapped camera mode:
• All cameras are delayed so that in Live mode all cameras are on the same timecode.
• Recalling local clips will not be instantly available: the network copy of the remote
cameras should occur before the clip can be recalled.
8.10. Disconnecting from XNet
When you work on the XNet Network and exit Multicam, the system checks if other
systems are still connected to your server.
If this is the case, the following message appears:
Other users are connected to your LSM
on XNet network. Are you really sure
that you want to close the Multicam
application ?
[ESC]=CANCEL [ENTER]=YES
• Press ESC to cancel the command and return to the application.
• Press ENTER to exit the Multicam application.
172 8. Operation on XNet Network
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013