Deleting clips, Introduction – EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual User Manual

Page 67

4.4.3.

Deleting Clips

Introduction

You can delete any clip available on disks as well as growing clips, but:

•

Loaded clips cannot be deleted.

•

Clip that are on air cannot be deleted.

•

In network mode, clips included in a playlist or currently used by another operator
cannot be deleted.

In these cases, a warning message is displayed.

Additionally, the deletion must be confirmed in the warning message box that appears:

•

When the clip is protected.

•

When the Confirm del clp/plst parameter is set in the Operational Setup menu (p.5.1
F3).

Note
When a clip is deleted, all playlists are scanned and that clip is removed from all
of them.

In the Remote Panel Interface

Deleting a Single Clip

Note
The F_ key corresponding to the clip location on the Remote Panel must be
green to be able to delete it.

To delete a clip, proceed as follows:

1. Select the page and bank where the clip that you want to delete is stored.

2. Press CLEAR, then press the F_ key corresponding to the clip.

Warning
In most cases, no confirmation is required and the clip will be instantly deleted.

3. If a confirmation message appears, press ENTER to confirm the selected clip

deletion.

OPERATION MANUAL Multicam LSM 11.02

4. Clip Management