EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 143)

Multicam Behavior
When adding a cut to a clip, Multicam will behave as follows:
• The transition applied at the cut point is a cut (for both audio and video).
• The speed of the cut elements is the same as the original element, even if it is
“Unknown”.
• The stop and start modes of the cut elements are auto.
• Any loop defined on the playlist that includes the original element conserves and
includes the cut elements.
• Any tag defined and active on the original element at the cut point is recreated at the
short-in of the second cut element.
How to Add Cut to a Timeline Element
To add a cut to a timeline element in a timeline opened in Edit mode, proceed as follows:
1. Jog to the position where you want to add a cut.
2. Press MENU to access the Edit mode secondary menu.
3. Select the Add Cut option (B key) in the secondary menu.
The timeline element is cut in two parts that keep the same LSMID.
OPERATION MANUAL Multicam LSM 11.02
6. Timeline Management 133