EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 206)

9.5.3. Controlling the Hypermotion Camera from
the Remote
Introduction
This section presents the various commands you can use on the remote panel to control
the hypermotion camera. The corresponding command on the hypermotion camera is
mentioned when available.
The standard behavior, applicable to all cameras (Photron, Vision Research and ARRI) is
first explained. When a given camera has a specific behavior, this is explicitly mentioned.
Remote Keys
Key Description
PLAY This key corresponds to the ‘Play’ command on hypermotion
cameras.
Press the PLAY key on the remote to initiate a replay from the first
available frame on the current memory block.
The corresponding CAM key flashes green to indicate the playback
status.
SHIFT+PLAY There is no corresponding command on hypermotion cameras.
Press the SHIFT+PLAY keys on the remote to initiate a replay on the
current memory block at the speed defined in the PGMSpeed
parameter.
Press again PLAY, SHIFT+PLAY, or PRV CTL to return to the
normal playing speed.
The corresponding CAM key flashes green to indicate the playback
status.
Mark This key corresponds to the ‘Mark Cue Point’ command on
hypermotion cameras.
With a single-block memory, press Mark to mark a cue point on the
current block. You can mark up to 255 cue points on a memory block.
This function is not available on all cameras with multiple-block
memory.
Last Cue This key corresponds to the ‘search’ command on hypermotion
cameras.
If cue points have been defined, press Last Cue to go to the previous
cue point of the current memory block.
If no cue points have been defined, press Last Cue to stop the
recording and go back to the first recorded frame of the current
memory block.
196 9. Advanced Control Modes
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013