EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 209)

To define the number of memory blocks on a hypermotion camera, proceed as follows:
1. In the hypermotion menu, press MENU to open the secondary menu.
2. Press A to activate the # Blocks field. This field specifies into how many memory
blocks the camera memory will be split.
3. Jog to select the number of blocks (1 to 4).
4. Press MENU again to validate your choice and come back to the hypermotion main
menu.
The camera memory is now split into the requested number of blocks, all with the same
size. The A to D CAM keys now correspond to the 1 to 4 memory blocks respectively.
Color Code for Memory Block Status
The memory blocks status are displayed using a common color code both directly on the
corresponding CAM keys on the LSM Remote Panel, and on the OSD monitoring of the
recorder corresponding to the hypermotion camera.
On the OSD monitoring, the block system is displayed as a suite of 4 squares, nnnn,
each corresponding to a memory block.
The common color code is as follows:
Color CAM Key Block Symbol
Memory Block
Status
Steady white Block 1
1 Empty block
Steady green Block 1 or
2 Recorded block
Blinking green Block 1 Block in PLAY
Steady red Block 1 Block in REC
Steady green Block 1 Block in REC
Blinking green Block 1 Block in REC
1 Empty transparent square.
2 White square for the NAC Camera Hi-Motion I only.
OPERATION MANUAL Multicam LSM 11.02
9. Advanced Control Modes 199