EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 32)

3.2.2. 1PGM+PRV Primary Menu Controls
Introduction
The primary menu in 1PGM+PRV mode, illustrated below, gives access to the functions
detailed in the following paragraphs:
Rst Cam Local Sync Prv 2nd CTRL
Cam A Cam B Cam C Cam D
CAM A / B / C / D
Rst Cam Local Sync Prv 2nd CTRL
Cam A Cam B Cam C Cam D
If PRV CTL is 'OFF', select the camera to assign to the PGM output. This camera key
will be highlighted in the menu.
If PRV CTL is 'ON', select the camera to assign to the PRV output. This camera key will
be highlighted in the menu.
Note
In 5CAM configuration (5 recorder channels and 1 player channel) or when
loading a clip where CAM E or F exists, the operational menu will display:
Rst Cam Local Sync Prv 2nd CTRL
Cam A Cam B Cam C --->
By pressing the D key (--->), the operator has access to the D, E and F
cameras. The operation menu becomes:
Rst Cam Local Sync Prv 2nd CTRL
Cam D Cam E Cam F <---
Press the D key (<---) to return to CAM A, B, and C selection.
Rst Cam
Rst Cam Local Sync Prv 2nd CTRL
Cam A Cam B Cam C Cam D
This function restores the position of cameras on the active channels: CAM A on PGM1,
CAM B on PRV.
Note
When a clip/playlist is loaded on a channel, switching back to Live mode will
recall the record train, which was last used on that output. This avoids too
frequent uses of the Rst Cam function.
22 3. Control Modes
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013